、

Cold storage is relatively low-temperature refrigeration equipment. The installation technology and requirements for cold storage are very important. There can be no carelessness or slack. As the saying goes, "Three points for quality, seven points for installation". If the installation technology is not in place, it will cause many problems and failures. Even the use cost will increase linearly, and the service life of the equipment will be greatly reduced. As a result, the installation and construction will also be painful for the entire industry. So today we mainly know the basic requirements and precautions for cold storage installation. The cold storage manufacturer will analyze them for you:
Basic requirements for cold storage installation:

1. Cold storage installation units need to provide cold storage users with knowledge training on how to use and manage the cold storage and some after-sales services.
2. Emergency lighting lamps, alarm devices and safe passages shall be installed in the cold storage to facilitate self-rescue or alarm for help in case of emergency.
3. The location of cold storage installation should be in a stable and convenient place; (If it is a local fruit grower, it is recommended to install it near the fruit source.)
Precautions for Cold Storage Installation:
1. The cold storage should be installed in a place as hot as possible from the heating appliance, otherwise not only the cooling efficiency will decrease, but also the storage board will be damaged sometimes. In addition, the ambient temperature range to ensure the normal operation of the unit is within 35 degrees. There is also room for overhaul of the unit.
2. It is strictly prohibited not to ground wire or not to ground wire at the required position; Otherwise, it will cause static electricity and even electric leakage in the body shell, endangering personal safety; Yellow and green double-color wires can only be used as grounding wires, not for other purposes.
3. It is strictly prohibited to use non-standard power cord in cold storage installation; All special lines of cold storage shall be equipped with line protection devices such as air switch or leakage protection, otherwise fire may be caused due to heating of plugs, sockets, wires, etc. If there is no corresponding air switch or leakage protection switch, it will not be able to prevent short circuit and leakage accidents caused by equipment failure or accidents, and it will not be able to disconnect the power supply in time, which is easy to cause fire and personal injury accidents.
The above is the introduction of the basic requirements and precautions for the installation of cold storage. I hope the above contents can help everyone to solve problems.